Content and implementation of waxed concrete kit at

2. ragrate with our glue grouting glue which constitutes the most adequate support. Wait for the full drying of the wicking (1 day / mm thick) before applying thecoating waxed concrete lime. (It may be useful to include in our wicking The reinforcement grid To strengthen the coherence of the bottom and avoid the risks of cracking) for smooth surfaces (printed plaster plates, smooth concrete, existing paintings) Prepare the support with the Under the lime hanging layer. Mixture of the mixture In an adapted container, mix the dose of pigments with the amount of water indicated on the label of waxed concrete (avoid lumps and mix well. Gradually pour the powder of theWaxed concrete coating lime In the water-colored mixture by effectively kneading. Adjust the consistency by adding a little water if necessary to obtain a nice dough pleasant to work.

Application

L’coating Waxed concrete with lime is generally applied in two layers to Fresco with a final thickness of 2 to 3 mm using a plate. Apply the first layer with a plate regularly, let it dry, but not completely. When it is possible to walk on socks, implement a second pass Waxed concrete with lime. On the ground, use boxes to put your bucket your knees on the first still wet layer.
Note: for clear colors, in order to limit the blackening of the surface during the iron, avoid stainless steel and preferably use a plastic plate. Once dry on the surface (after about 24 hours), it is possible to sand thecoating waxed concrete lime Dry hand or machine (sander, mono brush, etc.) with a very fine grain.

Protections

After full drying of thecoating (count 1 day per mm thick or 3 days for 3 mm), waterproof the supports with our waterproof oleofuge Easy-floor In at least 2 layers (see technical sheet). Note: For surfaces on the ground or technical surfaces that are very demanded such as a kitchen worktop for example, we recommend complementary products to l’easy floor such as BI component varnish and/or waxes (Solid wax in carnauba, liquid wax..)

Drying

L’coating Waxed concrete with lime is practicable with precautions after a few days. Hardness to heart, and therefore optimal resistance, is only obtained after about thirty days of drying.
Take a few precautions during the first days: put tampons under the feet of the furniture, wait minimum 10 days before putting the carpets back. During the first three weeks clean if necessary with a slightly damp cloth or mop, a soft broom and the vacuum cleaner. Then, for daily maintenance, use current household products by avoiding acidic and too alkaline products. Cleaning with our Marseille soap is advised.

CONSUMPTION

Allow approximately 1,250kg of concrete for 1m².

Practical advice

Water tool cleaning immediately after use. Implementation temperature: from + 5 ° C to + 30 ° C. Do not use on hot or humid supports. Each section of wall or floor surface should be finished during the day. Tops must be located at natural stops (angles, doors, etc.). Protect the neighboring parts from possible projections if not clean immediately. Precaution of use Non -dangerous product. Contains alkaline materials. In case of contact with eyes or skin to wash thoroughly with fresh water and consult a specialist if the symptoms persist. Keep children out of reach. Do not throw the residue to the sewer. Make them dry before eliminating them.

CONSERVATION

L’coating Waxed concrete with lime Keeps 1 year in closed original packaging sheltered from frost, humidity and hot weather. The information contained in this sheet is the expression of our knowledge and test results, it can in no case be considered neither as providing a guarantee, nor as engaging our responsibility in the event of defective application. It is recommended to make a control surface.

These subjects could also interest you: